Administrator: added Category:SIP using HotCat

2025-04-02T10:15:55Z

← Older revision		Revision as of 10:15, 2 April 2025
Line 32:		Line 32:

	[[Category:R2D2]]		[[Category:R2D2]]
			[[Category:SIP]]

Administrator: added Category:R2D2 using HotCat

2025-04-02T10:15:51Z

added Category:R2D2 using HotCat

← Older revision		Revision as of 10:15, 2 April 2025
Line 30:		Line 30:
	OK		OK
	</syntaxhighlight>		</syntaxhighlight>

			[[Category:R2D2]]

Administrator: Created page with "This command creates or deletes rule for routing incoming call on GSM port defined by port_index on given SIP device. SIP device is defined with parameter sip_device_ip_address which is in format: IPAddress[:listeningPort]. Called number is defined with parameter destination_number (this number will be used in the SIP To header in INVITE message). Last parameter in the command defines if rule will be created ("ADD") or deleted ("REMOVE"). It is optional and its default..."

2025-04-02T10:15:45Z

Created page with "This command creates or deletes rule for routing incoming call on GSM port defined by port_index on given SIP device. SIP device is defined with parameter sip_device_ip_address which is in format: IPAddress[:listeningPort]. Called number is defined with parameter destination_number (this number will be used in the SIP To header in INVITE message). Last parameter in the command defines if rule will be created ("ADD") or deleted ("REMOVE"). It is optional and its default..."

New page

This command creates or deletes rule for routing incoming call on GSM port defined by port_index on given SIP device.

SIP device is defined with parameter sip_device_ip_address which is in format: IPAddress[:listeningPort]. Called number is defined with parameter destination_number (this number will be used in the SIP To header in INVITE message). Last parameter in the command defines if rule will be created ("ADD") or deleted ("REMOVE"). It is optional and its default value is "ADD".

Note: if there is a SIP route defined on particular GSM port, and on the same port command WaitAndAcceptCall is executed, it will have higher priority.

When GSM incoming call is received, WaitAndAcceptCall command will end, and SIP routing will still be active

'''COMMAND'''
{| class="wikitable"
!Command
!Line Arguments
!Returns
|-
|'''RouteGsmPortToSip'''
|PortIndex, SipDeviceAddress, DestinationNumber, Command (ADD/REMOVE)
|In the case of error, Error Code
|}
'''OUTPUT'''

Command status in the following format:

"%s\n", command_status

'''EXAMPLE'''<syntaxhighlight lang="text">
~# RouteGsmPortToSip 1 10.2.5.125 8888
OK

~# RouteGsmPortToSip 1 10.2.5.125:5061 8888 REMOVE
OK
</syntaxhighlight>

RouteGsmPortToSip - Revision history

Administrator: added Category:SIP using HotCat

Administrator: added Category:R2D2 using HotCat